Installation process of ultrasonic humidifier

　　When installing the ultrasonic humidifier, it is necessary to determine whether the environment is suitable, and in what environment should the humidifier be installed best? Now let's take a look at how to correctly install the humidification equipment.

　　First, the maximum relative humidity of the required humidification environment. In the required humidification environment, when the maximum relative humidity is higher than 75% RH, the humidifier equipment should be installed outside the required humidification environment; When the maximum relative humidity is lower than 75% RH, the humidification equipment can be installed in the humidification environment. If there is a lot of floating dust in the humidification environment, which may cause the equipment to have poor air intake, the equipment shall be installed outside the required humidification environment. If the Celsius temperature in the required humidification environment is lower than zero, the equipment shall be installed in a place where the Celsius temperature is higher than zero outside the required humidification environment.

　　After the installation position of the humidifier equipment is determined according to the above conditions, the equipment installation height should also be considered. Generally, the fog outlet port of the equipment should be set at the top of the humidification site, within 50cm from the top, and the vertical distance between the fog outlet port and the equipment should be reduced as far as possible to maximize the transmission efficiency of fog. Therefore, the atomization humidification equipment should be installed at a high position as possible.

　　After selecting the installation site and installation height of the ultrasonic humidifier equipment, the mist outlet pipeline can be connected according to the specific conditions in the humidification site: first, if there is a high-speed air flow source in the humidification site, such as various high-speed fans, various gas injection ports, etc., the port of the mist outlet pipeline should be set below the air flow source, and the outlet should be upward, so that the high-speed air flow source can be used for uniform gasification and diffusion; If the air flow is relatively static in the humidification site, it is necessary to consider extending the fog outlet pipeline in the humidification site, evenly distributing the fog outlet ports, and forming an angle of 30 degrees between each fog outlet port and the horizontal, so that the humidification water mist can float and gasify naturally.

Read recommendations:

H02 mini fan heater Heater Fan

A25 aroma diffuser.essential diffuser

Can an air purifier remove smog?

essential oil diffuser manufacture

F10 neck fan Cooling Fan