Installation and location selection of industrial humidification equipment.humidifier diffuser Production

　　The installation location of the equipment can be selected from the following factors: 1) the maximum relative humidity of the required humidification environment, and the maximum relative humidity of the required humidification environment

　　When the humidity is higher than 75% RH, the humidification equipment shall be installed outside the required humidification environment; When the maximum relative humidity is lower than 75% RH, the humidification equipment can be installed in the humidification environment when

　　Medium. 2) The required humidification environment has explosion-proof requirements; All the explosion-proof requirements of the required humidification field, and the humidification equipment shall be installed in the non-explosion-proof area outside the required humidification environment.

　　3) If the Celsius temperature in the required humidification environment is lower than zero, the equipment shall be installed in a place where the Celsius temperature is higher than zero outside the required humidification environment. 4) Required

　　If there are a lot of floating dust in the wet ring, which may cause the equipment to not work smoothly, the equipment should be installed outside the required humidification environment.

　　After determining the installation position of the equipment according to the above conditions, the installation height of the equipment should also be considered. Generally, the fog outlet port of the equipment should be set at the top of the humidification site,

　　Within 50cm from the top, and the vertical distance from the fog outlet port to the equipment should be reduced as much as possible to maximize the mist transmission efficiency. Therefore, the atomization humidification equipment should

　　Consider installing at high position as much as possible. After selecting the installation site and installation height of the equipment, the mist outlet pipeline can be connected according to the specific conditions in the humidification site; First, such as

　　If there is a high-speed air source in the humidification site, such as various high-speed fans, various gas injection ports, etc., the outlet pipe port should be set at the end of the air source

　　Below, the outlet is upward, so as to make use of the high-speed air source to evenly gasify and diffuse; If the air flow is relatively static in the humidification site, it is necessary to consider adding

　　Connect the mist outlet pipe for a long time, evenly distribute the mist outlet ports, and make each outlet branch port form an angle of 30 degrees upward and horizontal to make the humidified water mist float and vaporize naturally.

Read recommendations:

F12 Cooling Fan

A2 aroma diffuser.essential diffuser

Why use an air purifier?

mini air purifier wholesaler

mini humidifier manufacturer