Industrial humidifier manufacturer's workshop humidifier.air humidifier Processing

　　Industrial humidifier manufacturer's workshop humidifier uses high-frequency ultrasonic vibration to transform the fog into a microbicine of 1-5 microns, so that the fog-shaped object spreads into the gas through the pneumatic device, thereby surpassing the effect of symmetrical moisture. No mechanical equipment, no noise, no pollution, low maintenance efficiency, low energy consumption, high atomization efficiency, simple and reliable maintenance.

　　The upper end of the stainless steel reflector of the workshop and the lower end of the water tray has an ultra -temperature protection device. When the equipment will exceed the temperature and the humidity of the equipment after the power is disconnected or at a low pressure, the protective device will destroy the working status of the ultrasonic humidifier, causing the workshop to call the police with a humidifier. The humidification device of the heating furnace consists of a heating furnace, steam nozzle, water inlet solenoid valve, drainage valve and its liquid level controller.

　　The principle of electric heating ultrasonic humidifier When the air humidity of the factory is lower than the set value, the computer outputs the data signal of the workshop humidifier, connects the switch power supply, and opens the relay, and the water will rise to the liquid level of the container. When the workshop is started with a humidifier, the current in the water (harmful chemicals) in the water causes movement, slowly heating up, and the steam is generated after the melting point.

　　Within more than ten minutes, the amount of water vapor with a humidifier in the workshop is large, continuously overflowing from the steam exit, entering the evaporator of the shell air conditioner, and then sent to the main room from a centrifugal fan to increase the humidity of the natural environment air. When running normally, water supply solenoid valves are opened every ten minutes. After a certain period of time, industrial humidifier manufacturers will leave a lot of residues, and the poor areas of water will be more obvious. These residues staying for a long time will form dirt layer, so the drainage solenoid valve in the system software will be opened in time to discharge the remaining water.

　　The manufacturer of infrared induction industrial humidifier in the workshop is composed of high -strong toughness squarestone lamp tube, stainless steel reflector, volatile water disk, humidity overload protector, water inlet electromagnetic valve, manual regulating valve, and humidified liquid level controller. The principle of infrared sensor ultrasonic humidifier When the air humidity of the factory is less than the set value, the computer output industrial humidifier manufacturer number data signal is connected to the switching power supply to make it high toughness. According to the reflective surface of the stainless steel reflector, the water can be volatile into the exhaust system software in S ~ 6s, and the use of the humidifier in the workshop is used. Automatically control the water level through the floating tube switch and water inlet solenoid valve to achieve automatic water supply. If the water flow is too small or water -free, the switching power supply of the AC contactor electromagnetic coil in the LED light system software with an infrared sensor in the infrared sensor will automatically cut off according to a certain device and stop working.

Read recommendations:

A14 Aroma Diffuser

J17 Air Humidifier

Application of air purifier

table fan Manufacturing

humidifier diffuser company