CREATIVITY CHANGES YOUR LIFE

Tel: +86 0755-84870739

Email: info@nexhc.com

Home  >  News  >  Optimization dedicated

News

Company news | Industry news | Exhibitions and events | Optimization dedicated | aromatherapy diffuser |

Common problems of industrial ultrasonic humidifiers, do you know?

source:Optimization dedicated    release time:2022-09-15    Hits:     Popular:aromatherapy diffuser direct sales

  J1 water humidifier Air Humidifier

  Industrial ultrasonic humidifiers are more and more widely used in the industrial field. Among industrial humidifiers, ultrasonic industrial ultrasonic humidifiers use high-frequency variations of ultrasonic waves. Ultrasonic industrial ultrasonic humidifier has the advantages of high compressive strength, uniform humidification, high humidification efficiency, environmental protection and energy saving, long service life, environmental protection and humidity balance, independent maintenance without water, etc. Industrial ultrasonic humidifier is also called electric heating industrial ultrasonic humidifier. The principle is to heat the water in the heated body to 100 degrees to generate steam, which is transported by the centrifugal fan. Therefore, the electric heating industrial ultrasonic humidifier is a very simple humidification method. The disadvantage is that the electric heater has high power consumption, no empty burning, low safety performance, and simple calibration.

  Then, according to the industrial humidifier FAQ, the application should be started after 30 minutes under the room temperature standard;

  1. Do not touch drinking water containing dirt, oil, acid or alkali. Industrial ultrasonic humidifier humidification. Keep the environment clean by continuing to clean the sensor surface;

  2. The atomization control module and the inner cavity of the shell in the storage tank of the industrial ultrasonic humidifier should be cleaned in time, usually once every 2-3 months;

  3. When the industrial ultrasonic humidifier system software is not used, the excess water in the storage tank should be discharged to avoid long-term leakage and foam generation of the atomization control module, accelerate the embrittlement speed, and endanger the service life of the industrial ultrasonic humidifier.

  4. When the equipment is used for a long time, if the above treatment still cannot solve the problem, please remove and replace the energy chip or make an atomization control module


Read recommendations:

A9 Aroma Diffuser

A16 Aroma Diffuser

Is the air purifier only for winter?

aroma diffuser wholesaler

aromatherapy diffuser Factory

Latest news

Hot

Inquiries

Contact the following for inquiries regarding our services and products.

Inquiry form