What are the requirements and location requirements of ultrasonic humidifiers?

　　With the recognition of the application effect of ultrasonic humidifiers, more and more industries have begun to use ultrasonic humidifiers for removing electrostatic removal. Among them,

　　In particular, the paper industry has the largest demand. Paper processing products that can more effectively eliminate static electricity through the ultrasonic humidifier spray through the ultrasonic humidifier, which is relatively traditional to remove

　　The method of static electricity has the advantages of more effective and convenient and energy -saving. So in the face of users who use the ultrasonic humidifier for the first time, everyone is setting up

　　There may be more problems in the installation, such as how to install ultrasonic? What are the installation location of ultrasonic industrial humidifier equipment

　　Require?

　　First of all, the ultrasonic humidifier needs to determine whether the environment is suitable when installation. In the environment that needs to be humidified, the maximum relative humidity is higher than 75%RH

　　At this time, the installation of the moisturizing machine equipment should be outside the required humidification environment; when the maximum relative humidity is less than 75%RH, the humidifier equipment can be installed in the humidity environment

　　middle. Secondly, there are more floating dust in the humidified environment, which may cause the device to not air in air. The equipment should be considered to install the equipment on the required humidification ring

　　Overseas. If the temperature within the required humidification environment is lower than zero, the equipment needs to be installed in a field with a degree of degrees Celsius higher than zero outside the required humidification environment

　　Place. Finally, consider the equipment installation height. Generally, the fog port of the device should be set at the top of the humidity place, within 50cm from the top,

　　And should minimize the vertical distance from the fog port to the device in order to maximize the efficiency of gas mist transmission. Therefore, the ultrasonic humidifier should be considered

　　Possible installation at a high position. Of course, there are many factories that need to link the PVC out of the atomic road according to the specific circumstances.

　　Inside, there are high -speed air flow sources, such as a variety of high -speed fan, various gas injection ports, etc. At this time, the port port port port should be set in the gas flow source

　　Below, the exit is upward. If the airflow is relatively static, it can be lengthened to the fog port directly.

Read recommendations:

F13 Cooling Fan

L06 Night Light

the on-board air purifier according to the category of the main pollutants in the car

F07 Cooling Fan

desk fan sales