Circular Wet Film humidifier system selection.humidifier diffuser manufacture

　　1. Selected type of humidifier host

　　1. The air -conditioning unit with a wet film humidifier with a thickness of D, the rear part of the cooler is reserved, and the length of the air section is the best.

　　2. The air -conditioning unit of the wet film humidifier with a thickness of D, the bottom of the humidifier installed must be connected to the water tray, and the space of the humidifier should be reserved in the water disk.

　　3. The wet film humidifier should be vertical when installing, and the left and right angles should not be greater than 5 degrees.

　　4. The water supply pipe and the 220V/50Hz power supply three -core socket must be provided on the site. The water and the power supply must be led to the installation location of the 0.5 -meter range from the electric control box of the humidifier, and there must be no obstacles around the surrounding area.

　　Second, the choice of wet film host width and height and circulating water tank width

　　1. Assuming that the circulating water humidifier humidifier system is installed on the air conditioner cooler: W (width) = the width of the heat exchanger, H (height) = the height in the air conditioner box.

　　2. General situation (wet film height) = height in the air conditioning box.

　　3. Selection of circulating water tank width {Wet film thickness+200mm when the total air volume is less than 5000 (m3/h)

　　Wet membrane thickness+300mm when the total air volume is 50000 ~ 15000 (m3/h) ㎡

　　Wet membrane thickness+400mm should be greater than 150000 (m3/h)

　　4. The selection of circulating water tank height {200mm when the total air volume is less than 50,000 (m3/h)

　　260 mm When the total air volume is 50,000 ~ 15000 (m3/h)

　　300 mm When the total air volume is greater than 15000 (m3/h)

Read recommendations:

TS06

A3 aroma diffuser.essential diffuser

Air purifier use classification

aromatherapy diffuser manufacture

portable air purifier