Trouble shooting method for fogless industrial humidifier

　　If there is no fog after the factory humidification equipment is cleared, it is recommended to replace the ultrasonic atomizing plate. If it is the problem of switching power or spray, please repair it; If the humidification equipment in the industrial ultrasonic factory cannot be removed, it is recommended to replace the ultrasonic atomizer plate or spray.

　　Trouble shooting method for fogless industrial humidifier

　　If the ultrasonic atomizing plate is not cleaned and maintained in time during use, the atomizing plate immersed in water will produce a lot of dirt after long-term use, so the humidification equipment cannot operate normally, resulting in reduced or no fog.

　　There are many reasons for no fog of humidifier, such as scale on impact plate of corrosion resistant humidifier. When no fog is found in the humidifier, first check the cause, the industrial dedusting humidifier, and then take effective measures. Common causes and troubleshooting methods of no fog of corrosion resistant humidifier are as follows:

　　Troubleshooting method I for fogless industrial humidifier: troubleshooting method for anti fogging (cleaning ultrasonic atomizing plate)

　　Pay attention to the converted cleaning water when cleaning the spray. Change the water every day and clean it every week. If it is applicable to ordinary drinking water humidifier, it shall be cleaned on time, and stainless steel water tank, atomizing plate, water storage tank, etc. shall be cleaned with special cleaning agent.

　　Trouble shooting method for fogless industrial humidifier Troubleshooting method II (liquid filling)

　　The humidification equipment has wind and no fog, and the drinking water is used for a long time. The scale causes the scale on the faucet, which cannot operate normally, and the atomization is naturally reduced or cannot be sprayed. Solution: You can use the white rice vinegar talent and add a little salt to reasonably dissolve the scale.

　　The impact plate scale of the humidification equipment was found not to spray water mist during use, which may be due to the formation of scale on the impact plate due to the long humidification time of the impact plate and the failure to work normally.

　　The third troubleshooting method for fogless industrial humidifier: dissolve the scale on the impact plate with white vinegar, clean the impact plate, and then reinsert it to test whether the humidifier can work normally. In general, it should be noted that pure water or boiling water corrosion-resistant humidifier humidifying industrial humidifier will not appear fog during use. There are only two reasons for fog.

　　There are many reasons for non fogging of corrosion-resistant industrial humidifiers. If there is no fog, first find out the cause gradually, and then find out the troubleshooting method for normal fogless industrial adder

　　Troubleshooting method IV for fogless industrial humidifier: detect the air outlet:

　　When the industrial processor is started, whether all the spray work normally and the wind cannot be discharged. If the spray does not work, it is necessary to check whether the electrical components and switching power supply of the corrosion resistant industrial humidifier are all normal, and whether the spray is damaged. The fan rotates to expel the fog. If you can see fog blowing out at work, the fan may be broken. Antidote, stuck when not working for a long time, add some grease and gently kiss, try it, if it is not easy to find after-sales service.

Read recommendations:

A17 Aroma Diffuser

A25 aroma diffuser.essential diffuser

How to do skin hydration care in a cost-effective way！

electric fan wholesale

desk fan Vendor