The cause of the ultrasonic humidifier does not have fog and the method of failure.water humidifier Processing

　　There are many reasons for moisturizing equipment, such as the humidifier shock film scaling. When the humidifier cannot be found, first check the cause, industrial dust removal and humidifier, and then take effective measures for the cause. The common causes and fault exclusion of the humidifier do not have fog are as follows:

　　An ultrasonic humidifier anti -fog anti -fog method (clean ultrasonic atomizer)

　　Cleaning the sprayer should pay attention to the cleaning of clean water after the conversion, and the water must be replaced every day, and it should be cleaned every week. If you apply ordinary drinking water to add a humidifier, you need to clean it on time, and use the special cleaning agent to clean the stainless steel sink, ultrasonic atomizer and water storage tank.

　　Ultrasonic industrial humidifier failure method 2 (plus liquid)

　　The humidification equipment has no fog, and drinking water for a long time. Dirty stabilization causes dirt on the faucet. It cannot run normally. The atomization naturally decreases or cannot be sprayed. Solution: You can add a little salt with white rice vinegar to reasonably dissolve the scale.

　　The humidification equipment shakes the dirt. When used, it is found that the water -free mist spray is sprayed. It may be that the humidification tablet is too long, resulting in the formation of shocking tablets, and it cannot work properly.

　　Method of failure to get fog: dissolves the scale on the shocking tablet with white vinegar, clean the shocking tablet, and then re -contain to test whether the humidifier can work properly. In general, it should be noted that the humidifier industrial humidifier with pure water or boiled water humidifiers will not have fog during use.

　　There are many reasons why the humidifier is not fog in the ultrasonic industry. If you can't get fog, you must first find out the reason, and then find out the normal ultrasonic humidifier.

　　Test the outlet:

　　When the ultrasonic humidifier starts, it causes whether the fog is all working normally. If there is wind, it cannot be out. If the centrifugal fan is not running, it is necessary to check whether the industrial humidifier electrical components are required. The fan rotates to discharge the fog. If you can see the misty water at work, it may be that the electric fan is broken. Solze, you can get stuck if you do n’t work for a long time.

　　Solution that is not foggy caused by the humidifier air outlet of the workshop: Replace the switch power supply or centrifugal fan, and change the fan.

Read recommendations:

TS01

F21 Cooling Fan

The principle and structure of air purifier to remove formaldehyde!Air purifier Vendor

mini air purifier wholesaler

table fan Factory