How to add water to ultrasonic humidifier.Humidifier manufacture

　　1. The principle of ultrasonic humidifier: fill the water storage tank and tighten the water tank cap before use. Put it on the base stably, switch on the power supply, and use the full-automatic humidity control button to select the appropriate ambient humidity; Turn on the main power switch, and the display light is on, indicating that the ultrasonic humidifier is working normally.

　　2. The fog water will spray out soon after the power is turned on. When the ultrasonic humidifier is used for humidification, the selection button will be able to select the appropriate amount of fog. Soon, the water will spray out. When the atomizer is used, the humidification component should be selected appropriately. The controller button will be able to select the appropriate amount of fog, and then the ultrasonic humidifier. Our daily life provides a comfortable and warm natural environment.

　　3. After the application of acoustic humidifier, be sure to select and apply cleaning water with temperature less than 40 ℃, and the cleaning steps are also very particular. Do not use cold water immediately. The ultrasonic humidifier must be placed horizontally, and then prevented from being exposed to the sun or close to the pyrogen. The gushing water mist does not need to be placed in the production workshop immediately? Electrical products, in case they fail.

　　4. Note that excessive humidity of the ultrasonic humidifier will also cause damage to the equipment. When the stainless steel water tank is plugged in, there must be no water or too little water flow in it to prevent damage to machinery and equipment. Be sure to use special cleaning type and aromatic agent for supporting facilities

Read recommendations:

F12 Cooling Fan

L02 Night Light

How is the air purifier constructed!air purifier covid Merchant

aroma diffuser direct sales

table fan Processor